Model
K3
UP to 300 lbs - 5" Wheels
|
 |
| Click here
for More Information |
Capacity up to 300 pounds per caster. These
institutional stem casters are ideal for most types of institutional equipment,
and are offered with a wide selection of wheels.
Features: * Swivel
Construction - Stamped steel. Swivel has double ball bearing with hardened
raceways. Metal cover shields swivel bearings from dirt and dust. * Axle - 3/8"
diameter bolt with lock nut. * Wheel Bearing - PS= Precision Sealed Ball
Bearings, B= Ball Bearings, D= Delrin Bearings, P= Plain Bore * Finish -
external metal parts are Zinc plated. |
|
Model
K3A
UP to 300 lbs - 3" thru 5" Wheels |
 |
| Click here
for More Information |
Capacity up to 300 pounds per caster.
These
institutional casters are ideal for any light duty application where the caster
must be totally immobile when the caster brake is applied. Caster Model K3A has
a unique brake which locks both the wheel and the swivel bearing at the same
time. This "Total-Lock" brake insures that the swivel caster will not turn
when the wheel is locked. This combination wheel brake and swivel lock is
essential for safety in some applications - such as on worktables, tablesaws,
and medical equipment. The Total-Lock brake is desireable whenever a brake is
needed because it makes a swivel caster totally immobile. The wheels featured
with Caster Model K3A are non-marking, and all except Polyolefin can be used on
hardwood floors. Polyolefin wheels are best at reducing the risk of a flat spot
occuring when loads are left standing for prolong periods. Gray Soft Rubber and
Polyurethane wheels have a sealed precision ball bearing. They provide floor
and cargo protection, quiet operation, and are very easy rolling. Try a set of
4 casters. You will be amazed at their performance! |
|
Model
9
UP to 900 lbs - 4" thru 8" Wheels
|
 |
| Click here
for More Information |
Capacity up to 900 pounds per caster. These rugged cold
forged casters are recommended only for manually moved applications. Model 9 is
our most popular industrial caster due to its widespread use throughout
industry and its low initial cost. Available with threaded stem and plain round
stem.
Features: * Swivel Construction - cold forged top plate and yoke
base from 1/4" steel. Swivel has double ball bearing with hardened raceways. *
Center Pin - 5/8" diameter, bolt and nut. * Legs - 1/4" thick, welded outside
only. * Lube Axle - 1/2'' diameter hollow bolt with lock nut. * Wheel Bearing -
R= Roller Bearing, B= Ball Bearings, D= Delrin Bearings, P= Plain Bore * Grease
Fittings - for swivel and wheel bearings. * Finish - external metal parts are
zinc plated |
|
