 |
This month's Tip is two fold...
Tip
1. Many times we have requests for longer 1/2" threaded stems on some of
our caster models. We only produce the most popular stem lengths but you can
make your own.
Ollie's Tip: On our
various Model 3 stem casters, we offer a "Stem" (or lack there of) option which
is called XHK1/2. This is actually a 1/2" hole thru the swivel bearing
to be used with a 1/2" bolt which you supply. The bolt slides thru the hole and
can be any length that you need. Remove the caster wheel (simple nut and bolt
axle), mount the caster bracket using your bolt and replace the wheel. It's
that easy.
Tip 2. Attaching a caster to the end grain of wood is
difficult. Using plate mount casters often puts the mounting screws on the
edges of the wood and the casters are not that secure. Others try to use a
threaded stem caster with T-Nuts. This is not a good solution either because
the T-Nut can loosen (even if epoxied) and the caster will not be securely
attached. How can we get a good solid installation into the end grain of
wood?
Ollie's Tip: Using the same
tip as above, substitute the 1/2" bolt with a 1/2" x 2 1/2" Lag Bolt as shown
in the photos. Drill a pilot hole into the end grain and attach the bracket.
This is a VERY SOLID installation.
|
