T-Nuts

Tips
BEFORE USING THE VERTICAL APPLICATION WITH THE T-NUTS CLICK HERE
How to use the Hollow Kingpin ( XHK1/2 ) Stem Option.

T-Nuts can be used to secure our threaded stem casters to wooden items. Here we show the typical use of the T-Nut for both a Horizontal and a Vertical Application.

In the Horizontal Application, you would drill a hole equal to the diameter of the barrel of the T-Nut and completely thru your wood. Hammer the T-Nut into the hole and thread your caster in from the bottom. This is the strongest mounting.

The Vertical Application is for attaching casters to the bottom of legs and into the end grain of the wood. This is not an exceptionally strong way to mount! Drill your hole equal to the diameter of the barrel of the T-Nut and to the depth of the length of the stem of the caster plus about 1/4". Apply 2 part epoxy to the T-Nut for additional strength. Hammer the T-Nut into the hole and thread your caster in from the bottom. You must use epoxy as we have had problems with some woods where the nuts ( and the casters ) fall off.
4 Prong T-Nut
3/8" - 16 Thread
Drill 7/16" Hole for Barrel
For Pricing and to Order
Click the Part Number Below

TN-3816
4 Prong T-Nut
1/2" - 13 Thread
Drill 5/8" Hole for Barrel
For Pricing and to Order
Click the Part Number Below

TN-1213

Photos & graphics are for informational purposes only. Actual product may vary slightly from those shown.
Wheel colors may vary unless specified. If wheel color is important, please contact us for current inventory.